• <div id="2wkky"><li id="2wkky"></li></div>
    <small id="2wkky"><div id="2wkky"></div></small><small id="2wkky"><button id="2wkky"></button></small>
  • <div id="2wkky"><li id="2wkky"></li></div>
  • <div id="2wkky"></div>
  • <div id="2wkky"><li id="2wkky"></li></div>
  • <small id="2wkky"><div id="2wkky"></div></small>
  • <small id="2wkky"><div id="2wkky"></div></small>
  • <li id="2wkky"></li>
  • <div id="2wkky"><button id="2wkky"></button></div>
  • <div id="2wkky"><li id="2wkky"></li></div><div id="2wkky"><li id="2wkky"></li></div>
  • 午夜男女爽爽影院动画


      >  Home > Composite insulator

    Composite insulator

    12kv composite insulator

    • Product ID:Composite insulator
    • Skype:richtang731
    • Phone: 18900751339
    • Tel: 0731-85499326
    • Email: sales@hncmec.com
    • Time: 2020-06-12
    • 咨詢

    Application for composite insulator distribution dead end type:
    Composite insulator dead end type is used for Deadend structures which are used where the transmission line either ends to follow a substation or when it turns through a large angle. The composite deadend insulator is in line with the conductor and under tension.

    End fitting and strength of composite deadend insulator:
    End ftting of composite deadend insulator was clevis and tongue and made of a commercial grad of malleable iron, ductile iron, steel, aluminum, bronze or brass. All ferrous part, other than stainless steel, was galvanized in accordance with the specification for Zinc coating on iron and steel hardware. Cotter key was made from cold drawn bronze, brass or austenitic stainless steel.
    Normally the strength of composite insulator distribution deadend type is 70kN and we Orient Power can also produce according to customers’ requirement.
    Voltage class and test for composite insulator distribution dead end type:
    According to ANSI standard the composite deadend insulator includes: 12kV,21kV,15kV, 25kV, 35kV 69kV.
    The tests are as follows:
    1. Electrical design test for composite deadend insulator:
    1.1 Low frequency dry flashover test
    1.2 Low frequency wet flashover test
    1.3 Critical impulse flashover test-positive and negative
    1.4 Radio influence voltage
    2. Quality conformance tests for composite insulator distribution dead end type
    2.1 Dimension test
    2.2 Galvanizing test
    2.3 Specified mechanical load test
    2.4 Retest procedure
    3. Routine test for composite deadend insulator:
    3.1 Tension proof test
    3.2 Visual examination
     IEC61109 and ANSI C29.13. 

    Scan the qr codeClose
    the qr code